The Mile Marker SEC12 -12000 lb winch for Jeeps/Trucks/SUVs has an impressive 12,000-pound pull strength allowing you to stand up to the most aggressive off-road environments. Powerful series-wound motors and rugged planetary gear sets are the backbone of this winch. With robust controls, fully sealed 400-amp solenoids and body, and an integrated kill switch, the SEC12 is an industry proven winch at an unmatched value. Built with marine grade remote control connectors and fully-sealed, submersible, water, mud, and snow proof. Each Steel Cable Version comes with a 3/8” x 100’ steel cable, a roller fairlead, the Synthetic Rope version comes with a 3/8” x 92’ synthetic rope, an anodized aluminum hawse fairlead. Both come with stainless steel hardware, a corrosive resistant body, and a handheld remote control with a 12′ cord.
Main Features:
• 4.9 HP Series Wound Motor
• Rugged Planetary Gear Sets
• Clockable Gear Housing
• Fast Line Speeds
• Submersible, 400 Amp Solenoid
• Automatic Load Holding Brake
• Corrosion Resistant Stainless Steel Fasteners
• 100’ Steel Cable Or 92’ Synthetic Rope
• Roller Fairlead (Steel Cable Version) Or Aluminum Hawse Fairlead (Synthetic Rope Version)
• Waterproof
• Handheld Remote Control.
During the installation, please confirm that the power switch is in the “OFF/O” position.
The battery release button must be at the top, align the contact point of the battery against the corresponding contact point on the battery slot, slide the battery in, and gently press until the battery is locked in place.
When removing the battery from Rhino Pull™ portable winch, confirm the power switch is in the “OFF/O” position.
Press down the battery release button and remove the battery.
The Mainline Purge System is designed to purge the air from your nitrous lines to allow immediate activation of your Nitrous system. This System includes a stainless steel purge solenoid, push button for activation, and a vent tube to direct the purged nitrous out of the solenoid. Also included is a -4 AN manifold to run inline with your nitrous feedline. This allows you to purge the nitrous system, even when you do not have a purge port built into your solenoids. The Purge system can also be used to lower the bottle pressure for spot on nitrous performance every time you activate the system.
Purge System includes:
Purge Solenoid.
4 AN adapter manifold.
Push button activation.
1/8 to 1/8 NPT Fitting.
1/8 NPT to Compression Fitting.
7 inches of 3/16″ Stainless Tubing.
If you run a larger -6 AN feedline, the correct Mainline purge system is PN# ML15601.
Reviews
There are no reviews yet!